Yazar "Tumer, M." seçeneğine göre listele
Listeleniyor 1 - 2 / 2
Sayfa Başına Sonuç
Sıralama seçenekleri
Öğe Evaluation of microstructural and mechanical properties of dissimilar Inconel 625 nickel alloy-UNS S32205 duplex stainless steel weldment using MIG welding(Springer Heidelberg, 2020) Tumer, M.; Karahan, T.; Mert, T.Inconel 625 nickel alloy and UNS S32205 duplex stainless steel (DSS) were welded with ER2209 filler metal using MIG (Metal Inert Gas) welding method. The weld metal obtained by DSS filler metal was subjected to mechanical and microstructural evaluation. Toughness and hardness properties had been examined by mechanical and microstructural characterization of weld metal, fusion line, and HAZ (Heat Affected Zone) region, and precipitations were investigated by light microscopy (LM), scanning electron microscopy (SEM), and energy-dispersive spectrometry (EDS). Corrosion behavior of base metals and face and root of weld metal were examined by using potentiodynamic polarization test. Additionally, detailed elemental analysis and mapping of weld metal with both optical emission spectrometer (OES) and X-Ray spectrometer were attained. Results demonstrate a significant decrease in toughness of the welding due to the presence of Nb and Mo rich intermetallic precipitations in the Inconel HAZ and root region, although there is no significant increase in hardness. Potentiodynamic polarization test shows that the dilution-induced microstructural transformation in the root of weld has the worst corrosion resistance in the weld metal. Therefore, this dissimilar welding does not have optimum properties for neither toughness nor corrosion.Öğe Investigation of microstructure, mechanical, and corrosion behavior of nickel-based alloy 625/duplex stainless steel UNS S32205 dissimilar weldments using ERNiCrMo-3 filler metal(Springer Heidelberg, 2021) Tumer, M.; Mert, T.; Karahan, TubaIn this study, nickel-based alloy 625 and duplex stainless steel (DSS) UNS S32205 (2205) dissimilar pairs were welded with metal inert gas (MIG) welding process. Weld metal, obtained with the utilization of ERNiCrMo-3 filler wire, was subjected to mechanical, microstructural, and corrosion investigations. V-notch impact tests and micro hardness measurements were realized on dissimilar weld metal. Microstructural changes in weld metal, fusion line, and heat-affected zone were examined using optical, scanning (SEM), and transmission electron microscopes (TEM) with energy-dispersive spectrometry (EDS). Phase precipitations rich of Nb and Mo were detected among dendritic austenite arms in the weld metal. It was observed that ERNiCrMo-3 filler metal had sufficient toughness because of high nickel content. Corrosion tests revealed that weld metal face pass is the least corrosion-resistant zone in weld metal unlike weld root. This is mainly because more intense intermetallics formed in weld metal face compared with the middle of the weld and the root.